Startup sequence (bus traffic)
When your setup doesn't work, it's hard to figure out where the problem lies.1. For just testing the software portion, use the "fake" adapter.
2. Compare the startup sequence looking at the bus traffic against a known good installation.
Test conditions:
1. Ubuntu 10.10 (64bit)
2. OWFS 2.8p3
3. Compiled with owtraffic to show serial line communication
./configure --enable-owtraffic
sudo make install
4. Started with debugging mode:
sudo /opt/owfs/bin/owhttpd --debug -d /dev/ttyUSB0 -p 4444
Each of the following pages shows a different adapter.
- Serial
- USB
- Network
- Zeroconf discovery
- Simulated adapter
Previous page: NetBSD
Next page: Startup DS9097U